Sensor toilet flusher is relatively common. When there is a little boy at home, a Sensor toilet flusher can be prepared for him. This kind of toilet flusher requires power and is very convenient. So, how to repair a leaky urinal? Let's take a look at it below.
1. The manufacturer of the Sensor toilet flusher tells you that you need to find the cause of the water leakage first, and check whether the flush switch has a water leakage problem. Sometimes because the flush switch is made of plastic, long-term wear and tear will fail to reset. It is necessary to check whether the rubber gasket is aging, or the sealing is not tight. If there is, it needs to be replaced in time before it can continue to be used.
2. The manufacturer of Sensor toilet flusher tells you that sometimes it is because the connection of the water inlet switch is loose, which will lead to continuous water leakage. In this case, we first need to tighten the connection of the water inlet valve switch. However, if the ball valve is not tightly sealed and has aging problems, it will also cause water leakage, and it needs to be replaced in time.
3. If there is water leakage at the bottom of the Sensor toilet flusher, first close the water inlet valve and wipe the bottom of the urinal clean. Then prepare the glass glue to put it on, you can apply some fine seam glue to cover the glass glue. After it is completely dry, the sealing effect can be achieved, and then open the water inlet valve to see if there is a problem of water leakage.